AR2800P Water Filter Replacement and Reset Instructions

 (PCT/RO Filters)

 

Step 1: Preparation

  • Turn off the water inlet valve.
  • Open the faucet to release any remaining pressure in the system.

 

Step 2: Replace the Filter

  • Twist and remove the filter (PCT or RO) that you want to replace.
  • Remove the rubber ring from the old filter and attach it to the new one.
  • Insert the new filter into the machine and twist it into the locked position.

 

Step 3: Flush the New Filter

  • Turn on the water inlet valve.
  • Keep the faucet open to flush the new filter.
  • Let water run for about 1–3 minutes (approximately 3–5 gallons) to fully flush the system.

 

Step 4: Reset the Filter Life

  • Locate the "R" button at the bottom of the machine.
  • Press the "R" button once — the screen will display the filter type (PCT or RO).
  • If the displayed filter is not the one you replaced, press the "R" button again to switch to the correct filter.
  • Once the correct filter is selected, press and hold the "R" button for 3–5 seconds until you hear a confirmation beep.
  • The machine will reset the filter life on the display.

AR2800P 淨水器濾芯更換及重置操作說明

(PCT / RO 濾芯)

 

步驟 1:更換前準備

  • 關閉進水閥門。
  • 打開淨水龍頭,釋放系統內殘留的水壓。

 

步驟 2:更換濾芯

  • 將需要更換的濾芯(PCT 或 RO)旋轉取出。
  • 從舊濾芯上取下橡膠圈,並安裝到新的濾芯上。
  • 將新濾芯插入機器,按照正確方向旋轉,直到鎖定到位。

 

步驟 3:沖洗新濾芯

  • 打開進水閥門,恢復供水。
  • 保持淨水龍頭開啟,沖洗新更換的濾芯。
  • 持續放水約 1–3 分鐘(約 3–5 加侖),確保新濾芯及系統內部充分沖洗。

 

步驟 4:重置濾芯使用壽命

  • 找到機器底部的 「R」重置按鈕。
  • 短按一次「R」按鈕,螢幕將顯示目前選擇的濾芯類型(PCT 或 RO)。
  • 如果螢幕顯示的不是本次更換的濾芯,請再次短按「R」按鈕,切換至正確的濾芯類型。
  • 確認選擇正確後,長按「R」按鈕 3–5 秒,直到聽到確認提示音。
  • 機器將自動重置該濾芯的使用壽命,螢幕上的濾芯壽命顯示也會隨之更新。

Ar 2800 P Water Filter Replacement And Reset Instruc Pdf

PDF – 102.2 KB 9 downloads